33
NON - PARTITIONED SYSTEMS
When partitioning is not being utilized, locations
572-586 can be used to control the arming and
disarming authority of the individual arm/disarm
codes. A code can be given limited authority by
programming a number from 1 to 15 in the
corresponding location for that code. Add the values
in the table below that correspond to the desired
arm/disarm characteristics, and program the sum in
the appropriate locations.
VALUE CHARACTERISTIC
1 STANDARD ARM/DISARM CODE
2 ARM ONLY AFTER CLOSING TIME
4 ARM ONLY CODE
8 OPEN/CLOSE REPORTS FOR USER
Location 587: Early-To-Open, Late-To-Close And/Or Automatic Arming Features
To enable the early-to-open and late-to-close features program a "1" in this location. If you also wish to enable the
automatic arming feature, program a "2" in this location. To enable both features, program a “3" in this location. A
time must be entered into locations 600-603 and 604-607 to enable these features. The Automatic Arming feature
will arm the Ranger 9000E at the selected time. At that time, the keypad sounders will sound for 50 seconds, warning
anyone who remains in the protected building that the system is about to automatically arm. If a valid code is not
entered before the end of the 50 second warning time, the system will automatically arm. If a valid code is entered,
a late to close signal will be transmitted. NOTE: If open/close reports are used, Automatic Arming will report user
28.
Locations 588-590: Communicator Code For Late-To-Close Report
The Ranger 9000E has the ability to report a 1 to 3 digit late-to-close report when these location(s) are programmed
and a closing time has been programmed in locations 604-607. Factory default is "0" for all locations and this feature
is not enabled.
Location 591: Select Phone #1, 2, Internal Log, Or Combination For Late-To-Close Reports (See Location
447)
Locations 592-594: Communicator Code For Early Opening Report
The Ranger 9000E has the ability to report a 1 to 3 digit early opening code when these location(s) are programmed
and a opening time has been programmed in locations 600-603. Factory default is "0" for all locations and this
feature is not enabled.
Location 595: Select Phone #1, 2, Internal Log, Or Combination For Reporting Early Opening (See Location 447)
Location 596-598: Communicator Code To Report Downloading Complete
Locations 596-598 contain the communicator report sent each time a download session has been completed. The
report will come in after a disconnect has been made from a downloading session. If these locations contain "0", this
report is disabled.
Location 599: Select Phone #1, 2, Internal Log, Or Any Combination To Report Downloading Complete
Locations 600-603: Opening Time
To enable the early-to-open report feature, a 4 digit 24 hour opening time must be entered in locations 600-603. For
example, to enter a opening time of 8:15 a.m.(08:15), program a "0" in location 600, a "8" in location 601, a "1" in
location 602, and a "5" in location 603. Factory default is a "0-6-0-0" which sets an opening time of 6:00 AM. NOTE:
A communicator code must be entered in location(s) 592-594 if this feature is selected.
(104 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern