CADDX Ranger 9000E Bedienungsanleitung PDF herunterladen (Seite 11)

Disconnect Existing Cellular

Hardware

Using the uControl Cellular Hardware

The uControl system provides superior protection for your home because alarm

events and security status can be communicated to you and to the central

monitoring station in the following ways:

•Internet

• cellular networks

• standard phone lines

Most home security systems do not have cellular communication devices integrated

into the alarm system. However, if you do have a separate existing cellular

hardware device wired into your alarm box, you need to disconnect this device to

use the uControl cellular hardware.

Disconnecting the Power from the Existing Cellular

Hardware

To take the external cellular device offline, you need to disconnect the power

supply and the backup battery. The cellular hardware device draws power from the

auxiliary power ports on the circuit board inside the alarm box. Perform the

following steps to disconnect the existing cellular hardware.

Step 1: Open the alarm box and unplug

the alarm phone cord

• Open the alarm box cover

a. If there are any screws holding your alarm

box door closed, use a screwdriver to

remove all screws holding the alarm box

front cover in place.

b. If the alarm box is secured by a lock, use

your key to open the front cover.

• Unplug the alarm phone cord.

a. Locate the gray alarm phone cord inside

the alarm box.

b. Unplug the gray alarm phone cord from

the telephone jack inside the alarm box.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 41 42

Keine Kommentare

CADDX Ranger 9000E Bedienungsanleitung Seite 11