CADDX Ranger 9000E Bedienungsanleitung PDF herunterladen (Seite 7)

Connect the Alternate Phone

Cord

Connect the Alternate Phone Cord to the Alarm System

If uControl is your first alarm-monitoring service, it is possible that your alarm

system might not have the proper connections to your home telephone line. Alarm

systems are designed to transmit alarm events through the telephone cable. The

uControl Link needs to monitor the telephone cable to capture these alarm events.

If your alarm circuit board is not connected to your phone cable, then you will need

to install the gray uControl alternate phone cable that connects the phone ports on

the alarm circuit board to the uControl hub. Complete the following steps to

connect the gray uControl phone cable.

Step 1: Open the alarm box

• Open the alarm box cover

a. If there are any screws holding your alarm

box door closed, use a screwdriver to

remove all screws holding the alarm box

front cover in place.

b. If the alarm box is secured by a lock, use

your key to open the front cover.

Step 2: Connect the gray

uControl cable to the phone

ports

• Find the gray uControl cable

a. Find the gray phone cable in the uControl package. This cable has a modular plug on one

end and four colored wires on the other end.

Note: In this procedure, you need to insert the tips of the four colored wires into

specific ports on the circuit board. However, the port numbers for the brown, gray,

green, and red wires differ between alarm models. Before you begin this

procedure, see the “List of Phone Ports” on page 29, find your alarm model in the

list, and write down the port numbers for each of the colored wires.

1 2 3 4 5 6 7 8 9 10 11 12 ... 41 42

Keine Kommentare

CADDX Ranger 9000E Bedienungsanleitung Seite 7